Axminster AW1416VS Spécifications télécharger pdf (Page 6)

Assembly Instructions

Please take some time to read the section entitled

“Illustration & Parts Description” to identify the

various parts of your machine so that you are familiar

with the terminology we will use to enable you

to set up and operate your table lathe safely and

correctly.

The machine and its accessories will arrive coated

with corrosion preventative grease. This will need to

be cleaned from the machine, its components and

accessories prior to it being set up and

commissioned. Use coal oil, parafﬁn or a proprietary

de greaser to remove the barrier grease. Be warned,

it will stain if you splash it on clothing etc., wear

overalls, coverall et al., rubber gloves are also a good

idea, as is eye protection if your cleaning process

tends to be a little bit enthusiastic. After cleaning,

lightly coat the machine with a thin layer of light

machine oil. N.B If you used parafﬁn/kerosene make

sure you apply this thin ﬁlm sooner rather than later.

95% of the machine comes fully assembled, (See

what’s included) to assemble the remaining 5%

please follow the instructions below.

Assembling the Carrying handles

Locate the two steel carrying handles (E) and the four

1/4 unc x 5/8" Phillips screws, attach them to each

end of the lathe bed (See ﬁgure 1).

Figure 01

Locate the two steel hooks & Phillips screws (G) and

screw them with the hooks facing inwards, into the

pre-drilled holes in the lathe bed. (See ﬁgures 2-3-4)

Assembling the Power Cable Hooks

Figure 02

Pre-drilled holes in lathe bed casting

Figure 03

Steel hook

Figure 04

Steel hooks in position

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Pas de commentaire

Axminster AW1416VS Spécifications Page 6